- Working Time: 1 hr
- Total Time: 2 – 3 hrs
- Skill Level: Intermediate
- Estimated Cost: $150 to $250
Installing a water hydrant in your yard is a great way to add a handywater source where you need it. The beauty of a frost-proofwater hydrant is that it drains itself every time you shut off the water, preventing water from freezing inside the faucet in winter. To ensure the frost-proof function works, the drain valve at the bottom of the hydrant’s standpipe must be buried below thefrost line,the depth to which the ground freezes in winter. This varies by climate, so check with your local building department for the recommended depth in your area.
Installing a water hydrant is easiest if you can tap into an existing undergroundwater supply line, such as the mainline for a sprinkler system. If a water supply is not available, you must run a new line to the water hydrant location. In the project shown here, the hydrant is being installed into a PVC water line near some in-ground sprinkler valves, where it is easy to cut into the supply pipe and add a tee fitting for the new hydrant.
Equipment / Tools
- PVC pipe cutter or hacksaw
- Tongue-and-groove pliers
- PVC pipe (sized as needed)
- PVC tee fitting
- PVC solvent glue
- Yard hydrant with standpipe and drain valve
- 90-degree elbow (sized for hydrant)
- MIP adapter (male-threaded x slip fitting)
- Plumber’s tape
- Additional PVC fittings (as needed)
- Scrap pieces of metal rebar (optional)
- 1/2-inch gravel
Dig Down to the Supply Pipe
Shut off thewatersupply to the underground supply line, if possible; otherwise, shut off the water to the house. Dig a large hole at the hydrant location, exposing enough of thewater supply pipe to provide ample room to work. Use only a hand shovel to prevent accidental damage to the pipe.
Install a Tee Fitting
Cut out a small section of the water supply line for installing a 90-degree teefitting, using a PVC pipe cutter or a hacksaw. Fit a short length of PVC pipe into the side outlet of the tee, but do not glue it in place. Permanently install the tee into the supply pipe with PVC solvent glue, following the manufacturer’s directions. When positioning the glued tee, use a level held along the short length of pipe to make sure the tee is perfectly horizontal.
If there isn’t enough room for a tee fitting, you may need to reconfigure the irrigation system manifold to provide more room to work.
Add the MIP Adapter
Install a 90-degree elbow and the MIP adapter onto the bottom of the water hydrant standpipe, usingplumber’s tape,tightening the fittings with tongue-and-groove pliers. The MIP adapter has male threads that attach to the elbow as well as a smooth (slip) socket that you will solvent-glue to the PVC water supply pipe.
For added protection against clogging, you can install a 1/8-inch, 90-degree elbow into the drain valve so it is pointing downward. This helps ensure the valve does not easily clog with dirt that can come in from the sides.
Complete the Job
Cut the pipes and install additionalfittings as needed to join the hydrant to the water supply tee fitting. Test-fit (without glue) all fittings to make sure everything fits correctly.
Glue all of the PVC pipes and fittings together, using solvent glue. If the water hydrant is heavy, it’sa good idea to support it with a few pieces of metal rebar tohold it in place while the glue dries. Let the glue cure as directed by the manufacturer. Turn on the water and inspect all connections for leaks.
Fill the bottom of the hole around the drain valve with 1/2-inch gravel to a level at least 3 inches above the drain valve; thisensures the hydrant drains properly. Fill in the remainder of the hole with soil, carefully compacting the soil with your feet as you go.